Clear the bottom right corner to clear the shield (shift + C) 27. Clear the warning (Place-Indicate-NO ERC) Shortcut key (PVN) 26. Automatically change the label (T-A) Select the order of comments Updatachang-Accept change-ValidataChanges-ReportChanges 22, Engineering (C-D) rule check 23, Message (error reminder after rule check) 24, Chip Show, (show all Pin VCC GND) 25. 7] - databus0 、、、 databus7 20 、 (M Device Lintlib) buzzer (Buzzer) usually use NPN to drive the buzzer, add a current limiting resistor (1K) 21. The quick link pin corresponds to the first connection, then ctrl + drag 18, (MCL)-Header2 two-pin pin 19, (bus-type connection) place the bus, place the bus entrance, place the label databus 【0. Shortcut key (P-N) Place the network label 16.
Copy the same component method (selected-ctrl + R) 14. Select - hold ctrl and drag again - change position (drag) 11. Change Original device value, click once, slowly click once, directly modify 9. Stand-alone components in the schematic diagram, hold shift and drag again = copy 7. Double-click the border bar to change the title bar properties 6. Application Template (Design-Template -Design template name-A4) 5. " 3, DXP-User Defined-PCB Shortcut Keys-,, Set Commonly Used Shortcut Keys 4. If the interference is wrong, change the "Design-Rules-Line Width. Compile the completed network diagram in the schematic diagram, and all connections report errors because the project has not been built build the project, add the SCH file that has been completed to it, and compile it.
0 kommentar(er)
